DFI LanParty 865PE User Manual download pdf (Page 47)

Hardware Installation

2.6.3 Floppy Disk Drive Connector

The system board is equipped with a shrouded floppy disk drive

connector that supports two standard floppy disk drives. To pre-

vent improper floppy cable installation, the shrouded floppy disk

header has a keying mechanism. The 34-pin connector on the

floppy cable can be placed into the header only if pin 1 of the

connector is aligned with pin 1 of the header.

Connecting the Floppy Disk Drive Cable

Install one end of the floppy disk drive cable into the shrouded

floppy disk header (J24) on the system board and the other end-

most connector to the drive you want to designate as Drive A. If

you are connecting another drive (Drive B), install the middle

connector of the cable to the drive. The colored edge of the

daisy chained ribbon cable should be aligned with pin 1 of J24.

BIOS Setting

Enable or disable this function in the Integrated Peripherals

submenu (“Super I/O Device” section) of the BIOS. Refer to

chapter 3 for more information.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 144 145

No comments

DFI LanParty 865PE User Manual Page 47