DFI LanParty 865PE User Manual download pdf (Page 40)

Hardware Installation

2.5.7 Universal Serial Bus Ports

USB 4

USB 3

Four onboard USB 2.0/1.1 ports (Black) are at locations CN7

(USB 1-2) and CN8 (USB 3-4) of the system board.

J10 (USB 5-6) and J11 (USB 7-8) connectors allow you to con-

nect 4 additional USB 2.0/1.1 ports. One of these connectors

allows you to connect to the 2 USB ports that are on the

FrontX device. (The FrontX device, which comes with

LANPARTY series products, must be installed into a drive bay of

the chassis.) Connect the USB cable connector from FrontX to

J10 or J11. Make sure pin 1 of the cable connector is aligned

with pin 1 of J10 or J11.

BIOS Setting

Configure the onboard USB in the Integrated Peripherals

submenu (“Onboard Device” section) of the BIOS.

If you are using a USB 2.0 device, you must enable the USB 2.0

function in the same submenu mentioned above. Refer to chap-

ter 3 for more information.

Driver Installation

You may need to install the proper drivers in your operating

system to use the USB device. Refer to your operating system’s

manual or documentation for more information.

USB 5-6

USB 7-8

USB 2

USB 1

VCC

-Data

+Data

Ground

Key

VCC

-Data

+Data

Ground

N. C.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 144 145

No comments

DFI LanParty 865PE User Manual Page 40