DFI LanParty 865PE User Manual download pdf (Page 43)

Hardware Installation

The front audio is disabled.

The rear audio is enabled.

The front audio is enabled.

The rear audio is disabled.

Pins 5-6 and 9-10 short

(default)

Pins 5-6 and 9-10 open

• Line-out Jack (Lime)

This jack is used to connect external speakers for audio output

from the system board. Using this jack disables the front au-

dio’s line-out function.

Center/Bass and Rear Out Jacks

Center/Bass and Rear Out Jacks (CN3) support 4 audio output

signals: center channel, subwoofer, rear right channel and rear left

channel. These 4 audio output signals together with the line-out

(2-channel) jack support 6-channel audio output.

Front Audio

The front audio connector (J1) allows you to connect to the

line-out and mic-in jacks that are on the FrontX device. Using the

line-out and mic-in jacks will disable the rear audio’s line-out and

mic-in functions. (The FrontX device, which comes with

LANPARTY series products, must be installed into a drive bay of

the chassis.)

Remove the jumper caps from pins 5-6 and pins 9-10 of J1 prior

to connecting the front audio cable connector. Make sure pin 1

of the cable connector is aligned with pin 1 of J1. If you are not

using this connector, make sure to replace the jumper caps back

to their original pin locations.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 144 145

No comments

DFI LanParty 865PE User Manual Page 43