DFI SB630-CRM User Manual download pdf (Page 14)

Introduction

Serial ATA

Serial ATA is a storage interface that is compliant with SATA 1.0a specifica-

tion. SATA 3.0 supports speed up to 6Gb/s while SATA 2.0 supports speed up to

3Gb/s. This improves hard drive performance faster than the standard parallel

ATA whose data transfer rate is 100MB/s. The board supports RAID 0/1/5/10.

Gigabit LAN

The Intel WG82579LM PHY and WG82574L PCI Express Gigabit controllers sup-

port up to 1Gbps data transmission.

USB

The system board supports USB 2.0 and USB 1.1 ports. USB 1.1 supports 12Mb/

second bandwidth while USB 2.0 supports 480Mb/second bandwidth providing a

marked improvement in device transfer speeds between your computer and a

wide range of simultaneously accessible external Plug and Play peripherals.

Wake-On-LAN

This feature allows the network to remotely wake up a Soft Power Down (Soft-

Off) PC. It is supported via the onboard LAN port or via a PCI LAN card that uses

the PCI PME (Power Management Event) signal. However, if your system is in the

Suspend mode, you can power-on the system only through an IRQ or DMA inter-

rupt.

Important:

The +5V_standby power source of y

our power supply must support

≥720mA.

Wake-On-PS/2

This function allows you to use the PS/2 keyboard or PS/2 mouse to power-on

the system.

Important:

The +5V_standby power source of y

our power supply must support

≥720mA.

Wake-On-USB

This function allows you to use a USB keyboard or USB mouse to wake up a sys-

tem from the S3 (STR - Suspend To RAM) state.

Important:

If y

ou are using the Wake-On-USB Keyboard/Mouse function for 2 USB

ports, the +5V_standby power source of your power supply must sup-

port ≥1.5A. For 3 or more USB ports, the +5V_standby power source of

your power supply must support ≥2A.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 182 183

No comments

DFI SB630-CRM User Manual Page 14