DFI LT600-DR User Manual download pdf (Page 34)

Hardware Installation

The VGA port is used for connecting a VGA monitor. Connect the

monitor’s 15-pin D-shell cable connector to the VGA port. After you

plug the monitor’s cable connector into the VGA port, gently tighten

the cable screws to hold the connector in place.

BIOS Setting

Configure the onboard VGA in the Advanced Chipset Features

submenu of the BIOS. Refer to chapter 3 for more information.

Driver Installation

Install the graphics driver. Refer to chapter 4 for more information.

VGA Port

VGA

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 147 148

LT600-DR/D/L 1
Copyright 2
Trademarks 2
Table of Contents 4
About this Manual 5
Warranty 5
Safety Measures 6
About the Package 7
Before Using the System Board 7
Chapter 1 - Introduction 8
Introduction 9
Features 10
System Board Layout 14
Hardware Installation 15
System Memory 16
Installing the DIM Module 18
Overview 20
Installing the CPU 20
Jumper Settings 25
PS/2 Power Select 26
USB Power Select 27
Power-on Select 28
Rear Panel I/O Ports 29
• Jumper Setting: 30
Serial Ports 33
VGA Port 34
USB Ports 35
LAN Ports 37
• Mic-in Jack (Pink) 38
• Line-in Jack (Light Blue) 38
• Line-out Jack (Lime) 38
I/O Connectors 40
S/PDIF-out Connector 41
Digital I/O Connector 42
Floppy Disk Drive Connector 43
Serial ATA Connectors 44
IDE Disk Drive Connectors 45
IrDA Connector 47
Cooling Fan Connectors 48
Chassis Open Connector 49
Power Connectors 50
Front Panel Connectors 51
Power LED 53
PCI Express Slot 54
Chapter 3 - BIOS Setup 56
Standard CMOS Features 57
BIOS Setup 61
Extended Memory 61
Total Memory 61
Advanced BIOS Features 62
↑> or <↓> to 64
Advanced Chipset Features 69
Integrated Peripherals 73
Power Management Setup 83
PnP/PCI Configurations 87
PC Health Status 89
Load Fail-Safe Defaults 92
Load Optimized Defaults 93
Set Supervisor Password 94
Set User Password 95
Save & Exit Setup 96
Exit Without Saving 97
File Name to Program : 99
Supported Software 101
Microsoft DirectX 9.0C Driver 102
(for Windows XP only) 102
Microsoft .NET Framework 3.5 103
3. Click Exit 104
Intel Graphics Drivers 107
Audio Drivers 112
Realtek LAN Drivers 113
Hardware Monitor for Windows 114
(for Windows XP) 119
(only LT600-DR) 121
Adobe Acrobat Reader 9.3 122
RAID Levels 124
Settings 125
7. Click Next 131
Bootable ISO. Click Next 131
Error Messages 143
Appendix D - Troubleshooting 145
Power Supply 146
Floppy Drive 146
Hard Drive 147
Parallel Port 147
Serial Port 147
Keyboard 148
System Board 148

Comments to this Manuals

No comments

DFI LT600-DR User Manual Page 34

Comments to this Manuals

Related products and manuals for Motherboards DFI LT600-DR