DFI CL630-CRM User Manual download pdf (Page 167)

167

System Error Message

When the BIOS encounters an error that requires the user to correct something,

either a beep code will sound or a message will be displayed in a box in the mid-

dle of the screen and the message, PRESS F1 TO CONTINUE, CTRL-ALT-ESC or

DEL TO ENTER SETUP, will be shown in the information box at the bottom. Enter

Setup to correct the error.

Error Messages

One or more of the following messages may be displayed if the BIOS detects an

error during the POST. This list indicates the error messages for all Awards BIO-

Ses:

CMOS BATTERY HAS FAILED

The CMOS battery is no longer functional. It should be replaced.

Important

Danger of explosion if battery incorrectly replaced. Replace only with the

same or equivalent type recommended by the manufacturer. Dispose of

used batteries according to the battery manufacturer’s instructions.

CMOS CHECKSUM ERROR

Checksum of CMOS is incorrect. This can indicate that CMOS has become cor-

rupt. This error may have been caused by a weak battery. Check the battery and

replace if necessary.

DISPLAY SWITCH IS SET INCORRECTLY

The display switch on the motherboard can be set to either monochrome or color.

This indicates the switch is set to a different setting than indicated in Setup.

Determine which setting is correct, either turn off the system and change the

jumper or enter Setup and change the VIDEO selection.

FLOPPY DISK(S) fail (80)

Unable to reset ﬂ oppy subsystem.

FLOPPY DISK(S) fail (40)

Floppy type mismatch.

Hard Disk(s) fail (80)

HDD reset failed.

Hard Disk(s) fail (40)

HDD controller diagnostics failed.

Appendix C - System Error Message

1 2 ... 162 163 164 165 166 167 168 169 170 171 172

No comments

DFI CL630-CRM User Manual Page 167