Dfi MB630-CRM User Manual download pdf (Page 48)

Hardware Installation

Chassis Intrusion Connector

The board supports the chassis intrusion detection function. Connect the chas-

sis intrusion sensor cable from the chassis to this connector. When the system’s

power is on and a chassis intrusion occurred, an alarm will sound. When the

system’s power is off and a chassis intrusion occurred, the alarm will sound only

when the system restarts.

MyGuard Hardware Monitor

Install the “MyGuard Hardware Monitor” utility. By default, the chassis intrusion

detection function is disabled. When enabled, a warning message will appear

when the chassis is open. The utility can also be conﬁ gured so that a beeping

alarm will sound when the chassis is open. Refer to the “MyGuard Hardware

Monitor” section in chapter 4 for more information.

Chassis

signal

Ground

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 170 171

No comments

Dfi MB630-CRM User Manual Page 48