Dfi CP100-NRM User Manual download pdf (Page 17)

Hardware Installation

Important:

When the Standby Power LED lit red, it indicates that there is power on

the system board. Power-off the PC then unplug the power cord prior to

installing any devices. Failure to do so will cause severe damage to the

motherboard and components.

System Memory

Important:

Electrostatic discharge (ESD) can damage your system board, processor,

disk drives, add-in boards, and other components. Perform the upgrade

instruction procedures described at an ESD workstation only. If such a

station is not available, you can provide some ESD protection by wearing

an antistatic wrist strap and attaching it to a metal part of the system

chassis. If a wrist strap is unavailable, establish and maintain contact

with the system chassis throughout any procedures requiring ESD pro-

tection.

DDR3-1

Standby

Power LED

The system board is equipped with two 204-pin SODIMM sockets that support

DDR3 memory modules.

DDR3-2

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 149 150

No comments

Dfi CP100-NRM User Manual Page 17